Procom Network Router Nav6 User Manual

ICS  
Technical Information  
Nav6 Computer Interface Instruction Sheet  
Using the Nav6 Computer Interface Cable  
Equipment required:  
Nav6 Computer Interface Cable  
(6020.09)  
PC (minimum specification : COM1 RS232 port, running “Windows HyperTerminal”, Procomm  
Plus” or a similar application)  
Note that this instruction sheet contains an expanded version of the instructions contained within the Nav6 User  
Manual 3008.00.  
Connecting a Nav6 to a PC  
The Nav6 can be setup to output NAVTEX messages and/or logged NMEA data to a PC.  
Follow these steps to enable communication between your Nav6 and a PC :  
Connect the interface cable to the PC’s RS232 port (usually COM1) & wire it into your Nav6 display as  
follows :  
Computer Interface cable colour  
Brown  
White (with black sleeve)  
Black  
Nav6 Lead cable colour  
Brown  
Black (paired with brown)  
Black (paired with red)  
Signal name  
RX  
TX  
0V  
Note : if you have a Nav6hub then follow the wiring instructions contained in the Nav6hub User Manual  
instead.  
Start up your terminal emulation application (“Windows HyperTerminal”, Procomm Plus” or a similar  
application)  
Set the serial port to 4800 baud, 8 data bits, 1 stop bit, no parity  
Test the connection by setting “manual print” to “On” and set the output format to “Data” ( Setup Mode,  
NAVTEX View, Options Page) and transmitting a NAVTEX message to the PC by pressing the PRINT  
softkey on the NAVTEX Mode, Print View  
Printing NAVTEX messages  
Set NAVTEX “auto print” to “On” (Setup Mode, NAVTEX View, Options Page)  
Set the NAVTEX output format to “Data” (Setup Mode, NAVTEX View, Options Page)  
Set the NAVTEX print filtering to select which message types from which stations should be transmitted to  
the PC (Setup Mode, NAVTEX View, Options Page, Print Setup)  
Auto printing of NAVTEX messages should now occur when new NAVTEX message transmissions are received  
from the selected stations  
Printing NMEA logged data at a fixed interval of time  
Set Navigate “auto print” to “On” and set the logging interval (Setup Mode, Navigate View, Options Page)  
Auto printing of Navigation logs will now occur at the chosen Navigate logging interval.  
Printing the Navigation log  
Set Navigate “manual print” to “On” if you want to be able to print the current page of log entries from the  
navigation log using the PRINT softkey on the Navigate Mode, Log View  
22/03/2002  
MAN3035.00.DOC  
1
 

Peavey Music Mixer SMRTM 821a User Manual
Peerless Industries TV Mount PT650 User Manual
Philips Computer Drive CD R RW User Manual
Philips Power Supply R6B4A230 User Manual
Philips Switch SWS2283W User Manual
Philips Telephone Accessories SDJ6360W User Manual
Philips TV VCR Combo 14PV111 01 User Manual
Poulan Trimmer PP333 User Manual
Precor Fitness Equipment S3 19 User Manual
ProForm Treadmill PFTL69712 User Manual